Does anyone run a single 40-44 IDF Weber carb with the linkage on the base? Well, I am having problems
as the throttle arm is held onto the cross shaft by 2 allen head set screws and they do not hold very well Tightening the set screws to where they will hold,
the tops strip out. and the arm slips. I was at Lone Pine and was losing power and no getup and go on any type of hill. I thought my motor was going
"South" but the arm had slipped and I was getting only 1/4 throttle pedal.
I was thinking of positioning the arm on the cross shaft where I wanted to be then mark the shaft at the set screw hole, drill and tap thru the shaft and instal a nut/bolt set up to hold it in place??
Any suggestions are welcome!
I was thinking of positioning the arm on the cross shaft where I wanted to be then mark the shaft at the set screw hole, drill and tap thru the shaft and instal a nut/bolt set up to hold it in place??
Any suggestions are welcome!
